Monday, November 26, 2012

Er9x, FrSKY and MultiWii Telemetry Sensor Integrate.

Used resources on the network, I integrate the sensor output show on my R/C transmitter. Thanks for the resources provided by the parties.

Target's battery voltage and RSSI show on my R/C transmitter, and it had function to set alerm for low voltage and low RSSI. I didn't need any more low voltage detector.

Target's latitude and longitude and altitude show on my R/C transmitter. It's useful for check that GPS is lock or not. Don't need check laptop or LED from control board.
Posted by at

4 comments:

  1. Steve In BrusselsMarch 11, 2013 at 2:57 AM

    If I understand properly. You have managed to take the data from the MultiWii and get it back to your ER9X via FrSky? If so -- this is tremendous. Please tell us more. This is what we need!

    ReplyDelete
    Replies
    1. SCTsaiMarch 13, 2013 at 4:54 PM

      Yes, you are right. Data path is from flight control board->frsky RX->frsky TX->ER9X.
      I just used the code from below URL.This is not my credit.
      http://www.multiwii.com/forum/viewtopic.php?f=7&t=1929

      Delete
  2. AnonymousFebruary 18, 2014 at 4:09 AM

    I wonder if this is possible to also do via the OPEN LRS tx/rx ?

    ReplyDelete
    Replies
    1. SCTsaiFebruary 19, 2014 at 1:53 PM

      I didn’t have this device. I think, if the tx/rx support the data transfer(ex UART channel).That’s feasible, maybe do something code modify and electronic modify.

      Delete

Subscribe to: Post Comments (Atom)